Novapoint 18.10.FP2c

Draw Map from Terrain Model

• Fixed: Using AutoCAD Map products took a very long time (hours).

  This is changed to produce LW Polylines directly to avoid problems with Convert in AutoCAD Map.
  All Polylines will if possible be LW Polyline.
  This will reduces time to draw map and will also reduce the AutoCAD DWG size significantly.

Draw Standard Cross-section… under Road - Drawing Generator is no longer available

Recommand use of Road - Draw Cross-Section - Draw Cross-Section from Road Model… and draw a sutiable profile for your standard cross section.

Configuration

• Fixed: WS-config did't remember all settings in predefined pipe/connection matrix. As a result the height of the top cover for the manhole was not copied to the manhole in the created trench.

Construction

• Fixed: When changing Project-ID the previous WS model was still active if some of the drawing functions had failed (memory was not updated).

Configuration

• Fixe in Norwegian W&S ini for Virtual Map.
• New ini for Sweden vm_modeler_BH90.ini.